ROYAL DEFENSIVE LT 1

Chemicals

It is a strong wateroilproof water based, food safe approved.
Ideal for all kinds of natural stone, it protects the surface from acid rain. Uv resistant.

Weight 1.5 kg
Dimensions 30 × 25 × 20 cm

14.50

Loading...

Description

Description
Anti stain water based impregnator treatment for marble, granite, cement and
terrazzo. Food safe approved & no solvent inside. This product penetrates the surface of the stone creating an invisible barrier against moisture and rising humidity and protection against stains: Oil, grease, coffee, tea, food, general dirt, mould and mildew.
The product will not change the natural aspect of the stone or create any type of film, allowing permeability vapour moisture to escape, and is UV-resistant.

Recommended use
• On polished, honed and matt textured finishing marble, terrazzo, granite, natural and artificial engineered stones, terra cotta, quarry, cement pavers.
• Natural finish for interior and exterior use.
• Effective for honed and polished natural stones – flooring –work surfaces (kitchen, bathrooms)
• Effective as pre- grouting treatment
• Suitable for line treatment.

Properties
This product penetrates the surface of the stone creating an invisible barrier
protection against stains: Oil, Grease, Coffee, Tea, Food, General Dirt, Mould and Mildew. Product will not change the natural aspect of the stone or create
any type of film, allowing permeability vapour moisture to escape, and is UVresistant.

Food safe contact approved referred to normative UNI EN 1186-1:2003 dtd 01/12/2009 and directive 82/711/CEE, 85/572/CEE, 89/109/CEE, 90/128/CEE,
92/39/CEE and 97/48 CE.

Application
All stone surfaces to be treated must be completely clean and dry.
Where no previous treatment experience exists a small discreet area should be
tested to verify the suitability of the product to the stone. Apply one coat of the product evenly by spraying using a low pressure pump up garden spray type unit or with a lamb’s wool applicator or by cloth in circular movements. The most efficient method is by spraying. On very absorbent surfaces apply a second or third coat allowing sufficient time between each application (20-30 minutes) to penetrate into the stone and dry. If in doubt test discreet area to ensure second or third application is necessary. In case of over treatment or any air bubbles remove by wiping excess product using a clean cotton cloth or absorbent paper. Temperature of surface to be treated should not be below 10ºC. Avoid direct sunlight especially for external works.

Drying time
Dry 1 hours, safe to walk on carefully. Fully effective within 48-72 hours before resuming normal use.

Pre Grout Treatment
Product can be applied while stone is damp. Apply over clean stone or tile surface minimum 3 hours before grouting. Final stone protection can be carried out with water based treatment later once stone clean and dry.

Coverage per lt
Indicative coverage allowing 2 coats subject to stone absorption, surface texture.
High Porosity Stone, Sandstone 3 – 5m²
Medium Porosity, Honed Stone, Limestone 6 – 10m²
Low Porosity, Polished Stone 10 – 20m²
Very Dense Stone 25 – 30m²

Additional information

Weight 1.5 kg
Dimensions 30 × 25 × 20 cm